QUALITY |
'ECI' Heat sealing (Non Adhesive) insulating tapes are manufactured from high grade virgin flexible PVC in many different sizes, thickness and colours. They are resistant to oils, chemicals, solvents and oxidation and have high tensile strength and excellent electrical properties. USES :- • ELECTRICAL INDUSTRIES :- 'ECI' TAPES are used for Insulation on Busbar, Switch-gears, Wire & Cable Joints, CT's and for Colour Identification. • ELECTRONIC INDUSTRIES :- In De'Gausing coil for coloured TV's and Monitors. • AUTOMOBILE INDUSTRY :- For wrapping on wire Harnessing and for protection and insulation. • ENGINEERING AND CHEMICAL INDUSTRY :- For wrapping on ferrous Pipes & Tubes, Wires & Cable to present and protect them against leakage, corrosion and acidic reaction. • GENERAL APPLICATION :- For Identification, sealing and decoration of articles. DIRECTION FOR USE :- Article to be covered should be over wrapped smoothly and tightly with 'ECI TAPE'. Both the ends should be stuck on the heating with a soldering iron or any other hot rod or by adhesive. Pressure to be applied for sealing. TEST DATA : For 19 mm width X 0.13 mm Thick Appearance : No visible defects Tensile Strength ( lbs / inch width) : 20 Elongation at Break : 240% Voltage Resistivity 20 0 C (Ohm-Cm) : 2 X 10 13 Water Absorbtion : less than 1% Electrical Strength : 5 KV AC 50 HZ for one minute Accelerated Ageing-12 0 to 90 0 C + 5 0 C : No sign of Cracking of deformity
'ECI' TUBINGS are manufactured from High Grade Virgin PVC, in various thickness, sizes, colours. Having very good electrical properties, they also resist chemicals, solvents and oxidation etc. • USES :- • ELECTRICAL & ELECTRONIC INDUSTRIES : 'ECI' Tubing are used for high quality insulation. • AUTOMOBILE INDUSTRIES : 'ECI' Tubing are used for wire harnessing and for protection. • TOY INDUSTRIES : For Decoration. PVC LACING CORDS 'ECI' LACING CORDS are manufactured from high grade virgin flexible PVC. Having very good electrical properties, they also resist chemicals, solvents and oxidation etc. They are vastly used in Electrical and Electronic industries for bunching of wires. ECI – POLYETHYLENE ( SPIRAL ) TUBE 'ECI' SPIRAL TUBE are manufactured from a high grade POLYETHYLENE ECI SPIRAL TUBE applies a strong grip develop both from its torsional cut and memory of Plastic material used. Its remains its strength under repeated flexing and bending, follows wire path easily, and makes neat, free-running cables. It is extreamly useful on long continous runs where many leads are required, wire can enter or break out nay point.ECI ( SPIRAL ) can be removed easily for troubleshooting and then re-applied. because of the excellent electrical and mechanical properties of the material used, has become one of the most widely used wire bunching devices for power transmission & telecommunication application.
|
